Parts and Supplies
This section contains all the parts necessary to build your very own mini-dome. The 3D printer is not included in this section. You will need a 3D printer to complete the project or have access to one for the printed parts. The parts list below provides the names, the amount needed for each part, and an approximation of the cost for each item. The link shortcuts direct you to Amazon, where you can purchase the parts if you do not already have what is needed. The project should cost around $100 to complete.
| Item Name | Amount | Cost | Link / Notes |
|---|---|---|---|
| Breadboard Kit with Arduino Uno | 1 | $39.00 | View item |
| MicroSD Card | 1 | $8.00 | View item |
| 1W 8ohm Round Speaker | 1 | $8.00 | View item |
| SG90 Servo | 2 | $18.00 | View item |
| MP3 Audio YX5300 | 1 | $7.00 | View item |
| Mini Audio Amp | 1 | $3.50 | View item |
| 220 OHM Resistors | 3 | — | In Breadboard Kit Above |
| 1K OHM Resistor | 1 | — | In Breadboard Kit Above |
| LED Lights | 3 | — | In Breadboard Kit Above |
| Arduino UNO | 1 | — | In Breadboard Kit Above |
| PLA Filament 1Kg | 1 | $25.00 | Whatever works |
| Rare Earth Magnets 6mm X 3mm | 2 | $12.00 | View item |
| Paper Clips (1 inch or less) | 2 | — | In Junk Drawer? |
| Hot Glue and Super Glue | 1 | — | Walmart, Amazon or the art teacher down the hall |
| M3 Nut and Bolt (15 or 20mm) | 2 | — | Hardware Store or Amazon |
| Mini Breadboard | 1 | — | View item |
| Buttons | 3 | — | View item |
| Zip Ties and Adhesive Zip Tie Mounts | 1 | — | View itemOptional: This is just for organization inside the dome if necessary. |
| Bundle of Red and Black Jumper Wires (M/M and M/F) | 1 | — | View itemOptional: To help with positive and ground connections. Red for positive and black for ground. |
